Spring bar and buckle
Measure your spring bar with calipers. 1.00–2.60 mm
The bar the short strap wraps around inside the buckle. Measure your buckle bar with calipers. 1–3 mm
Where the tongue wraps the buckle bar. Measure your tongue wire with calipers. 1.20–2.00 mm
Follows the lug width. Make it narrower for watches with pinched lugs. 8–30 mm
Across the strap. Set from the buckle width; match your buckle's tongue wire. 2–7 mm
Along the strap. Leave it empty to size it for your buckle's tongue. 6–16 mm
The least leather left between the tongue slot and each cut edge. 1–5 mm
Adjustment holes
Holes in the long strap for the buckle tongue. 1–12
Matches your round hole punch. 1–4 mm
Center to center. 6–10 mm
From the tip of the long strap to the center of the first hole. 20–60 mm
Taper
Where the strap narrows from the lug width to the buckle width. 10–50 mm
Full lug width before the taper starts, so the spring bar sits flat. 0–20 mm
Stitching
Set it on your wing divider or groover. 1.5–5.0 mm
Fitted so the holes come out even; with pricking irons, use exact iron spacing. Most straps use 2.4–4.0 mm (1–100 mm allowed).
Matches your iron or round punch. 0.5–2.0 mm
Stitch holes at each keeper end